Randy's Invisible Solar Attic Space Heating Collector

Here is another simple scheme for using solar heat from the attic to provide free space heating.

The lower plenum and collector channels formed by
the roof trusses.

Randy sheeted across the back of some of his attic roof truss bays to from the channels for a collector.  He then added an intake plenum at the bottom and a exhaust plenum at the top.  So, air flows from his living room via a 12 inch duct to the intake plenum, then up through the truss bays picking up heat from the under surface of the roof, and then into the exhaust plenum, and finally back to the living room via another 12 inch duct.  The flow is powered by an attic vent fan that includes a 93F thermometer to turn the system on when the attic air gets up to a useful temperature.

While the system is currently prototyped in cardboard to see how well it worked, Randy plans to replace the cardboard with rigid polyiso foam board.

One remaining challange is a good backdraft damper to prevent cold air from thermosyhphoning into the living room at night -- any ideas?

All the details on Randy's solar attic heat project...

Randy is planning to try picking up attic air to run the clothes dryer with.

The collector is invisible from the outside.

For more information on using solar attic heat ...

Note that I'm trying a new comment system that you will see when you go to Randy's project page -- I'd appreciate hearing any feedback on the system or problems using the system.

Gary